Water Test Vessel

Water and Oil Mix

1.2% Water in Oil

1/2% Water in Oil Sample

The water test kit is equivalent to the Mobil Wavis and Kittiwake units and will produce similar results.

No Water!

Water in lubricating fluids can cause serious damage to machinery with premature failure of bearings, gears, pistons and other components. Major bearing manufacturers claim that as little as .05% water in the oil will reduce bearing life by as much as 60%.

Until now, there hasn't been an easy and convenient way to determine water content on-site. Samples have always been sent to the lab while the people in the field waited for the test results. Now, the Water Test Kit can be used to determine the percentage of water in various fluids right at the machinery's location. Test results are available in as little as five minutes. Typically these fluids are hydraulic fluids, gear oils and other circulation system lubricants. Not only can these fluids be tested, but others can also be tested. The maximum range of the gauge is 1.5% water, but lower or higher concentrations (.15% or 12% Full Scale) can be tested using the laboratory techniques listed in the operating manual.

With a resolution of 0.01% (100 PPM) water, any fluid can be tested as long as the following conditions are met:

• A. The water must be in the form of free molecules or droplets and not be chemically or physically bound as in an emulsion.

• B. The fluid should not attack the water vessel components which are anodized aluminum, brass and the epoxy used to mount the Reagent Chamber.

• C. Most importantly, the fluid testing must not have a flash point below 140^o F. The Water Test Kit, # 01-WATER-TESTSB, contains the water test vessel, one box of Reagent A (# 01-REAGENT-A), 1 liter of Reagent S (#01-REAGENT-S-LT), a 10 and 30 milliliter syringe and instructions.